Product Description Model NO.: Z3XJ1-200/210 Coils Shaping: Stator Forming Stator I.D: 80~120mm Stack Height: 20~160mm Power Supply: 380V/50/60Hz 1.5kw Dimension: 1600*1000*2300mm Transport Package: 1 Ply-Wooden Case Origin: China Condition: New Vertical Shaping: Stator Shaping Stator O.D: Max 200mm Displacement of Cylinder: 20L Weight: 1000kg Trademark: NIDE Specification: Customized HS Code: 8479819000 This Forming Machine has a wide range and easy to operate. The stator coils will be automaticly formed or shaped by machine tooling. The inner coils will be expanded, while the outside coils will be wrapped. This machine  is consist of machine framework, oil hydraulic power system, control system, and forming tooling system. 

Technical parameter:

Stator O.D	less than 160mm
Stator I.D	30~110mm
Stack height	20~150mm
Displacement of cylinder	20L
Power supply	1500 W
Voltage	380V/50/60Hz
Weight	700KG
Dimension	L850*W1000*H2300mm

Machine main function and characteristic
1. This machine adopts whole hydraulic system and PCL program.
2. This machine can adjust the forming stack length by changing washer.
3. Both slot paper and wedge should not be damaged or turned over. The stator should not be deformation or stator lamination should not be upward. There is no wire enamel broken.
4. Production capacity ≤13s/set (exclude loading/unloading time)
5. Primary qualification rate ≥99.5%, after rework, the rate ≥99.9%
6. This machine adopts safety grating protection system. Operator need to stand when operating.
7. Machine adopts two hands simultaneously start button to ensure safety.
8. Primary qualification rate ≥98.5%, after rework, the rate ≥99.5%
9. His machine adopts safety grating protection system. Operator need to stand when operating.
l0.Machine adopts two hands simultaneously start button to ensure safety.

Machine operation steps
1. After connected to the power source and air source, switch the button to on. Press hydraulic start button; switch to auto mode.   
3. Press "reset" button. Check if all parts are in the correct position.
4. Put stator into the groove. Press "Start" button by two hands. Machine will auto form.
 
Note: there are two triangle blocks (diagonal line) in the groove. The two holes on the stator should be aligned to the two triangle blocks separately. And make sure the wire should be put together as below picture.
 

Contact us if you need more details on Forming Machine. We are ready to answer your questions on packaging, logistics, certification or any other aspects about Winding Forming Machine、Stator Forming Machine. If these products fail to match your need, please contact us and we would like to provide relevant information.

Product Categories : Stator Winding Line > Lacing And Forming Machine